Klarstein New Breeze 7 Bedienungsanleitung Seite 44

EN
44
Drainage way as follows
In cooling or drying operation, the condensation water will be drained to the chassis
and spattered by water- striking motor. As the temperature of condenser is high, most of
the condensation water will be evaporated and drained to outdoor. So usually, only a
little condensation water will be accumulated inside the chassis and you do not need to
discharge the water frequently. When the chassis is full with water, the buzzer will give
out 8 sounds and „H8" is displayed to remind user to discharge water:
• Move the unit to a suitable place for discharging water; do not tilt the unit and keep
it horizontal during moving;
• Take the drainage pipe from the clip and pull out the rubber plug on the drainage
pipe to discharge water;
• After full water protection is eliminated and the compressor has been stopped for 3
minutes, the unit will resume operation.
Using a continuous Drainage
The water can be discharged automatically via the central outlet. You will need the
supplied rubber hose, hose adapter and hose clamp. This is how you set up the drain:
Remove the continuous
drain cap 1 by turning it
counter clock- wise then
remove the rubber stopper
2 from the spout.
Screw the drain connector
to(included in the
package) the spout by
turning clockwise.
Put the hose on the
adapter and fasten it with
the hose clamp. Guide the
free end of the hose into a
suitable drain.