Storage; Troubleshooting; Disposal - Silvercrest SWKG 2000 B1 Bedienungs- Und Sicherheitshinweise

Cleaning and Care / Storage / Troubleshooting / Disposal
Therefore regularly descale the glass kettle (varies
by lime content in the water and frequency of use).
Only use citric acid or lime dissolver suitable for food
containers from a houseware shop (e.g. coffee maker
cleaner), do not use acetic acid or other acids.
Fill the water reservoir
to a simmer.
Add some citric acid or lime dissolver suitable
for food containers from a housewares shop
(e.g. coffee maker cleaner).
Unplug from the protective ground socket. Lime-
scale will dissolve as the water cools.
Occasionally swivel the water reservoir
Repeat the process for thick layers of limescale.

Troubleshooting

Problem
The device is not
functional.
The water kettle switches
off early.
The device does not
switch off.
The kettle does not
switch on.
In the event of malfunctions not specified here, please
contact our Customer Service Department. Our
customer service representatives will gladly assist
you. The service address is listed in our terms of
warranty.
10 GB
114274_silv_Wasserkocher Glas SWKG 2000 B1_content_PL_HU_CZ_SK.indd 10
with water and heat
5
.
5
Cause
The device is not connected to the
protective ground socket.
The water reservoir is not properly
positioned on the base station
The ON / OFF switch has not been
3
activated.
The bottom of the water reservoir is
severely scaled.
The safety lid is not closed correctly.
8
The filter cartridge is missing or inserted
incorrectly.
The overheating protection was acti-
vated and the device has not yet cooled
down sufficiently.
note: Descaling may be interrupted, even if some
limescale remains. Descaling down to the bare metal
surface is not required.
After descaling, simmer 2–3 fillings of fresh water
and discard the water.

Storage

Once the glass kettle has cooled down and is
cleaned, proceed as follows:
If necessary, unplug the mains plug from the
protective ground socket.
Wrap the mains cable on the cable wrap of
the base station
.
4
Now store the glass kettle in a dry location.
Solution
Plug the mains plug into the protective
ground socket.
Correctly place the water reservoir on
. the base station
4
Push the ON / OFF switch
into the "|" position.
Descale the kettle as described in
chapter "Cleaning and Care".
Close the safety lid
operate the device with the filter car-
tridge correctly installed.
Allow the device to cool down.

Disposal

The product packaging is made
from recyclable materials. The
packaging material may be re-
turned to public collection sites
for recycling.
.
4
down
3
correctly. Only
8
06.08.15 08:53