Warranty Conditions; Declaration Of Conformity (Ce) - Steinbach 060935 Bedienungsanleitung

060935_v1911 EN
Important Note
Maintenance
To move the light around the edge of the swimming pool (Fig. 4) re-lea-
se the two M-6 x 70 screws (No 15). To remove the bulb release the
6 nuts which secure the ring on the base of the light (Fig. 8). Remove
the bulb (No 2) from the inside of the light base and undo the two clips.
Further loosen the two screws which secure the two clips to the light
(Fig. 9).
Replace the bulb and remount the light in the opposite order as de-scri-
bed in point 4, paying particular attention to the following points:
Connect the cable clips to the light using the two screws included
(Fig. 10).
Place the 95 x 7 O ring (No, 3) in the centre of its recess
Tighten the nuts fully.
Before handling, always make sure there is no electricity coming into
the light.
The new bulb should be the same as the orig-inal supplied with the light,
PAR 56, 12V.
To ensure water tightness, clean the bulb's O ring (No 3) bed, or replace
the O ring if you fi nd any notches or incisions or other perma-nent
damage.
Cleaning
Use conventional cleaning products. Do not use solvent-based or abra-
sive cleaning agents/tools, i.e. no hard sponges, brushes etc..
Storage
The product must be thoroughly dried after cleaning. After which, it is to
be stored in a dry location protected from frost.
Disposal
Disposing of packaging: The packaging material has been selected
in view of environmental concerns and disposability and is therefore
recyclable. The paper and cardboard can be recycled, as can the plastic
coverings.
Disposing of the product: Applicable in the European Union and other
European states with systems in place for collecting and sorting recycla-
ble materials. Dispose of the product in accordance with any laws and
regulations applicable at your place of residence.

Warranty conditions

The respective country's legal provisions for warranty conditions shall
apply accordingly.

Declaration of conformity (CE)

The EU declaration of conformity can be requested via the address
shown at the end of this manual.
7