Nissei DSK-1011 Bedienungsanleitung Seite 11

V I E W I N G T H E S A V E D R E A D I N G S ( M E M O R Y F U N C T I O N )
Turn off the monitor once with "START/STOP" KEY when the results are displayed after
a measurement.
Refer to page 4 for memory function.
1 TOUCH MEMORY KEY.
Touch MEMORY KEY [1] to review readings
saved in the memory bank [1] and MEMORY KEY
[2] to review those in the bank [2].
The average of the saved readings is displayed.
Note: Average will not be displayed unless there are
two or more readings saved.
2 TOUCH THE SAME MEMORY KEY AGAIN.
The latest reading saved in the selected bank is
displayed.
The display at the top shows memory number,
measurement date and time alternately. The latest
reading is displayed as memory "No. 1".
The results are recalled from the latest to the oldest
with operation of MEMORY KEY.
The bigger memory number indicates the older
number.
: Average
NUMBER OF SAVED RESULTS
MEMORY
NUMBER
TIME
DATE
-11-
SWIT HING ANKS
Touching MEMORY KEY [2] at display of reading in the bank [1] will switch the display
to reading in bank [2] and touching MEMORY KEY [1] again will return to the display of
result in the bank [1].
3 TURN OFF THE MONITOR.
Touch "START/STOP" KEY.
Even if you do not turn off the monitor, it displays the result for approximately 30 seconds
and will turn off automatically.
DELETING SAVED READINGS
Deleting individual readings
Touch the memory key to display the latest set of readings. Then scroll through the
readings by repeatedly touching the memory key until you reach the reading to be
deleted. Then hold down memory key for seconds until display ashes and continue
to hold down key for about 4 seconds until reading is deleted and the display is cleared
[ ].
Deleting all the readings in a memory bank.
Select and display the average readings for the memory bank to be deleted.
Then delete by holding down the memory key continuously until the display is
cleared [ ] as described in the sentence above for the deletion of individual
readings.