Troubleshooting - Vileda JetClean! Bedienungsanleitung

G
Easy Clean Storage Tray
see page 6 of this instruction manual.
To prevent any harm to delicate floors, always store the appliance in the storage tray. As the appliance works
with water, it could retain water and humidity that can damage delicate floors when not in use.
The storage tray can also be used for a quick clean of the microfiber roller before or after use. For a thorough
cleaning of the device, please refer to MAINTENANCE & CARE on page 11.
1
Place unit on Easy clean storage tray.
2
Ensure the dirt water tank is empty before running the cleaning mode. If not, empty the dirt water tank,
following the instruction for 'Empty and clean the dirt water tank', before running the cleaning mode.
3
Fill the water cup with 150 ml of water (until the mark), optionally add a drop of non-foaming floor cleaner
detergent.
4
Unwrap the power cord from the cord hooks, plug into main power socket, and press the power ON button.
5
Pour 150 ml of water into the water chamber at the back of the storage tray while the unit is ON! Allow the
cleaning mode to run 60 seconds untill all water flows through and has been picked up. Repeat if needed.
6
Once all water has been picked up, press the power OFF button. Unplug the unit from the main power socket.
•
Do not remove the plug by pulling the cable.
7
Empty and clean the dirt water tank, following the instruction for 'Empty and clean the dirt water tank'.
8 9
Open the nozzle cover and leave open to dry. From time to time, clean the storage tray under tap water and
let it dry completely before using again.
Note: Pour water in the easy clean storage tray only when the appliance is ON! If the appliance is not running,
the water will spill on the floor. If too much water is poared into the easy cleaning storage tray, this will spill onto
the floor. Do not leave the appliance unattended while the cleaning process in running.
Storage: Store the unit in a protected, dry area. Since the product uses water, it must not be stored where
there is a danger of freezing. Freezing will damage internal components and will void the warranty.
Problem description
Reduced spray OR no spray
12

5. TROUBLESHOOTING

Possible cause
• Clean water tank may be empty
• System isn't wet enough
• Roller nozzle cover is not latched
in place
• Water flow not activated.
• Internal system may be clogged
with dirt.
• Spray tips on nozzle clogged
Possible solution
• Turn OFF and unplug unit. Refill clean
water tank with cold water.
• Activate wet mopping by pressing the
clean water spray swtich on the
handle grip. LED lights will turn on
when water is being distributed. Move
the appliance back and forth to wet
the microfiber roller.
• Turn OFF and unplug unit. Remove
and re-position nozzle cover to firmly
click onto nozzle.
• Activate wet mopping by pressing the
clean water spray swtich on the
handle grip. LED lights will turn on
when water is being distributed.
• Turn OFF and unplug unit. Send unit to
authorized maintenance service.
• Turn OFF unit. Clean the nozzle holes
from dirt with descaling liquid.