Inhaltsverzeichnis
Werbung
Check the steps below if your spider doesn't move after adding
salt water.
1
Make sure motor and gears are installed in right position.
2
Make sure each connector must be set in right position (Ref:
3
Make sure cut off the burrs clearly on part B3 and B4.(Ref:
4
Make sure Fuel Cell plate is inserted entirely. (Ref:
5
Replace a new magnesium sheet if it is eroded as shown below.
(New)
6
Make sure that the Fuel Cell plate is placed in the correct sequence and position: air
cathode — nonwoven fabric — magnesium sheet. (Ref:
7
Make sure the air cathode black side is facing up. (Ref:
8
Nonwoven fabric is also used to isolate air cathode and magnesium sheet, make
sure the 2 parts do not come into contact each other or it may cause short circuit.
(Ref:
STEP
)
19
9
Salt water will easily cause oxidization, scratch oxide from the battery connectors
and also magnesium sheet by slotted screwdriver before reuse. See below figures:
P10
Magnesium
Sheet
6. Trouble Shooting
Scratch Here
P17
STEP
16
STEP
9
STEP
)
21
(Need to replace)
STEP
)
19
)
STEP
19
P1
Connector
)
)
Scratch Here
Werbung
Inhaltsverzeichnis
Fehlerbehebung
