Philips FC8919 Bedienungsanleitung Seite 14

English
14
Cleaning the permanent motor protection filter
Clean the permanent motor protection filter every time you replace the
dustbag.
1 Remove the dustbag holder with the dustbag.
2 Press down the tab at the top of the motor protection filter holder
to release it.
3 Pull the top of the motor protection filter holder towards you (1)
and lift the filter holder out of the dustbag compartment (2).
4 Shake the filter over a dustbin to clean it.
5 Put the clean filter back into the filter holder.
6 Fit the two lugs of the filter holder behind the ridge at the bottom
to ensure that it fits properly at the top (1). Then press the filter
holder home ('click') (2).
7 Place the dustbag holder with the dustbag back into the appliance
and close the cover.
Cleaning the washable hEPa 12 filter
The washable HEPA 12 filter is able to remove 99.5% of all particles down
to 0.0003mm in size from the outlet air. This not only includes normal
house dust, but also harmful microscopic vermin such as dust mites and
their excrements, which are well-known causes of respiratory allergies.
Note: To guarantee optimal dust retention and performance of the vacuum
cleaner, always replace the HEPA filter with an original Philips filter of the
correct type (see chapter 'Ordering accessories').
Clean the washable HEPA 12 filter every 6 months. You can clean the
washable HEPA 12 filter max. 4 times. Replace the filter after it has been
cleaned 4 times.