Specifications - Makita DHS630RTJ Betriebsanleitung

ENGLISH (Original instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Star marking
5. Indicator lamps
6. Check button
7. Lever
8. Wing screw
9. Cutting line
10. 45° position
11. 0° position
12. Screw

SPECIFICATIONS

Blade diameter
Max. Cutting depth
No load speed (min
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
• Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may
cause injury and/or fire.
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
6
Explanation of general view
13. Top guide
14. Switch trigger
15. Lock-off lever
16. Light
17. Shaft lock
18. Hex wrench
19. Loosen
20. Hex bolt
21. Outer flange
22. Saw blade
23. Inner flange
24. Dust nozzle
Model
at 90°
at 45°
-1
)
Net weight
BL1815N/BL1820/BL1820B/BL1830/BL1830B/BL1840/BL1840B/BL1850/
BL1850B/BL1860B
DC18RC/DC18RD/DC18RE/DC18SD/DC18SE/DC18SF
Save all warnings and
ENE028-1
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
GEA010-2
CORDLESS CIRCULAR SAW
SAFETY WARNINGS
Cutting procedures
1. DANGER: Keep hands away from cutting area
and the blade. Keep your second hand on
auxiliary handle, or motor housing. If both hands
are holding the saw, they cannot be cut by the blade.
25. Thumb screw
26. Hose
27. Vacuum cleaner
28. Clamp lever
29. Rip fence (Guide rule)
30. Adjusting screw
31. Triangular rule
32. Base
33. Limit mark
34. Brush holder cap
35. Screwdriver
DHS630
165 mm
66 mm
46 mm
3,100
346 mm
3.0 - 3.4 kg
D.C. 18V
GEB151-1