Specifications - Makita HP2071J Betriebsanleitung

ENGLISH
(Original instructions)
1 Lock button
2 Switch trigger
3 Speed adjusting dial
4 Higher
5 Lower
6 Lamp
7 Reversing switch
8 Arrow
9 Speed change knob

SPECIFICATIONS

Model
Speed
Concrete
Capacities
No load speed (min
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future refer-
ence.
HAMMER DRILL SAFETY WARNINGS
1. Wear ear protectors when impact drilling. Expo-
sure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
4
Explanation of general view
10 Action mode changing lever
11 Grip base
12 Side grip (auxiliary handle)
13 Teeth
14 Protrusions
15 Chuck key
16 Sleeve
17 Ring
18 Retaining ring
HP2070/HP2070F
High
20 mm
Steel 8 mm
Wood 25 mm
–1
) 0 – 2,900
0 – 58,000
Low
-----
16 mm
40 mm
0 – 1,200
0 – 24,000
364 mm
2.6 kg
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
ENE042-1 and could give the operator an electric shock.
4. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
5. Hold the tool firmly with both hands.
6. Keep hands away from rotating parts.
ENF002-2 7. Do not leave the tool running. Operate the tool
only when hand-held.
8. Do not touch the bit or the workpiece immedi-
ately after operation; they may be extremely hot
and could burn your skin.
9. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation
and skin contact. Follow material supplier safety
GEA010-1
data.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
GEB003-5 failure to follow the safety rules stated in this instruc-
tion manual may cause serious personal injury.
19 Hexagonal nut
20 Wrench 19
21 Depth gauge
22 Blow-out bulb
23 Power-ON indicator lamp
(green)
24 Service indicator lamp (red)
25 Vent holes
HP2071/HP2071F
High
20 mm
8 mm
25 mm
0 – 2,900
0 – 58,000
362 mm
2.6 kg
a/II
Low
-----
16 mm
40 mm
0 – 1,200
0 – 24,000