LD Systems U500 serie Bedienungsanleitung Seite 6

6
HEADPHONE OUTPUT
6.3 mm jack socket for connecting a headphone (dual receiver only).
7
HEADPHONE VOLUME LEVEL
Drehregler zum Einstellen der Kopfhörerlautstärke (nur Doppelempfänger).
8
Device for attaching the antennas for rack installation. Remove the covers, attach the BNC adapter to the front panel and connect the BNC
antenna connectors (Fig. 11, dual receiver) to the BNC adapters on the front panel (short antenna cable and BNC adapter included). Now, the
antennas can be attached to the front of the receiver.
9
Screw holes for 19" rack mounting.
11 15
10
DC SOCKET
Low-voltage socket for the power supply of the device. (Single receiver: DC 12V Plus internal/ 500 mA, Dual receiver: DC 12 V Plus internal/
1000 mA). Please only use the power adapter included.
11
ANTENNA A/B
BNC antenna connector A and B. For optimal reception, please connect the supplied antenna to the connectors A and B and point them
upward in "V" formation.
12
BALANCED OUTPUT
Balanced audio output with 3-pin XLR socket.
13
UNBALANCED OUTPUT
Unbalanced audio output with 6.3 mm jack socket.
14
INSTRUMENT / LINE
Level and impedance adjustment to instruments or line inputs for the unbalanced jack output. Using a suitable tool (e.g. a ball point pen), set
the switch to the down position INSTRUMENT, when connecting the receiver to the input of an instrument amplifier (guitar amplifier, bass
amplifier) and to the opposite position LINE, when connecting to the line input of a mixer or amplifier
15
BALANCED OUTPUT MIX OUT
Balanced audio output with 3-pin XLR socket (dual receiver only, signals from channels 1 and 2 are mixed).
16
UNBALANCED OUTPUT MIX OUT
Unbalanced audio output with 6.3 mm jack socket (dual receiver only, signals from channels 1 and 2 are mixed).
17
INSTRUMENT / LINE MIX OUT
Level and impedance adjustment to instruments or line inputs for the unbalanced jack output MIX OUT (dual receiver only). Using a suitable
tool (e.g. a ball point pen), set the switch to the down position INSTRUMENT, when connecting the receiver to the input of an instrument
amplifier (guitar amplifier, bass amplifier) and to the opposite position LINE, when connecting to the line input of a mixer or amplifier.
6
10 12 13 14
16 17 12 13
11 11
14 12 13 14 10 11