Technical Data; Inserting/Replacing The Battery; Initial Operation; English | 15 - Bosch BL 2L Professional Originalbetriebsanleitung

OBJ_BUCH-186-003.book Page 15 Monday, October 1, 2007 12:30 PM

Technical Data

Cross-line Laser
Article number
Working range
Levelling accuracy
Self-levelling range,
typically
Levelling duration,
typically
Operating temperature
Storage temperature
Relative air humidity, max.
Laser class
Laser type
C
6
Tripod mount
Batteries
Operating life time,
approx.
Automatic switch-off after
approx.
Weight according to
EPTA-Procedure 01/2003
Dimensions
Degree of protection
Please observe the article number on the type plate
of your measuring tool. The trade names of the indi-
vidual measuring tools may vary.
The measuring tool can be clearly identified with the
serial number 7 on the type plate.
Bosch Power Tools
Assembly
BL 2L

Inserting/Replacing the Battery

Professional
Use only alkali-manganese batteries.
3 601 K15 100
To open the battery lid 10, press the latch of the
10 m
battery lid 9 in the direction of the arrow and re-
move the battery lid. Insert the supplied batter-
± 0.3 mm/m
ies. When inserting, pay attention to the correct
polarity according to the representation on the
± 4°
inside of the battery compartment.
When the battery indication 3 flashes red, the
<4 s
batteries must be replaced.
– 20 °C ... +50 °C Always replace all batteries at the same time.
Only use batteries from one brand and with the
– 20 °C ... +70 °C
identical capacity.
90 %
Remove the batteries from the measuring
2 tool when not using it for extended periods.
When storing for extended periods, the bat-
635 nm, <1 mW
teries can corrode and discharge themselves.
>3.33
1/4"
Operation
3 x 1.5 V LR6 (AA)

Initial Operation

12 h
Protect the measuring tool against mois-
ture and direct sun irradiation.
60 min
Do not subject the measuring tool to ex-
treme temperatures or variations in tem-
0.45 kg
perature. As an example, do not leave it in
118 x 57 x 89 mm
vehicles for longer periods. In case of large
IP 54
variations in temperature, allow the measur-
(dust and splash ing tool to adjust to the ambient temperature
water protected) before putting it into operation.
Avoid heavy impact or falling of the measur-
ing tool. After heavy exterior impact on the
measuring tool, an accuracy check should al-
ways be carried out before continuing to
work (see "Levelling Accuracy").
Switch the measuring tool off during trans-
port or when carrying it by the carrying
strap 17. When switching off, the levelling
unit, which can be damaged in case of in-
tense movement, is locked.

English | 15

1 609 929 K01 | (1.10.07)