Training In Watt Mode - DKN AM-2 Montageanleitung Und Bedienungsanleitung

Training in WATT mode

•
Select "WATT", use up/down to set target watts
(programmable between 10 up to 350 Watt),
confirm selection by pressing "MODE".
•
The tension difficulty will be auto-adjusted
according to the Watt figure. If the figure is under
the target value, the tension difficulty will be up-
adjusted one level every 30 seconds, up to the
maximum level 32. As soon as you achieved the
set value, tension difficulty will be down adjusted
one level immediately. In case of overspec the
level will be down adjusted one level
immediately, and keep down-adjusting each 15
seconds until you reach the preset value.
•
If you donot intend setting Watts, simply press
"MODE".
Heart rate displayed is an approximate read-
out, and may not be used as guidance in any
cardio-vascular related medical or
paramedical program.