How To Access The Programming Mode; Key Menu - Coffee Selection - LaCimbali M39 Dosatron TE Gebrauch Und Installation

22. How to access the programming mode

N.B. ONLY if the item "Customer Progr." is set on
"YES" and the item "Program. block" is set on
"NO".
To access programming press the
message will appear on the display:
CUSTOMER PROG.
KEY MENU
Press one of the dispensing keys on the selection panel
(2
Use the (30) and (31) keys to position the cursor
(black line) on the desired line, then press the
Always use the (30) and
2) exit the menu and leave the settings unchanged by
pressing the key (24).

23. Key menu - Coffee selection

Press one of the coffee dispensing keys on the selection
panel (2
following message will appear on the display:
KEY MENU
Type
Water dose
Each dispensing unit is controlled by a panel that permits
programing the amount of desired dispensing for each
button.
- water dose (volumetric dosage pulses)
key (29
key (29).
(31) keys to change the
key
+
1 coffee
110
21 EN
Note: When modifying data, the cursor changes to "
", or a slide bar with maximum and minimum
settings will appear:
Water dose
0000
-
If the "Customer Progr." is set to "NO", the following
message will appear on the display:
CUSTOMER PROG.
NOT ENABLED!
0090
1999
+
2