HomeMatic IP HmIP-WRCC2 Montage- Und Bedienungsanleitung Seite 41

the openings of the battery compartment point
to the right and that the push-button properly
engages with the bracket.
Pay attention to the flashing signals of the LED (C)
•
after inserting the batteries (see "7.4 Error codes
and flashing sequences" on page 44).
Once the batteries have been inserted, the wall-mount
remote control will perform a self-test (approx. 2
seconds). Afterwards, initialisation is carried out. The LED
test display will indicate that initialisation is complete by
lighting up orange and green.
Caution! There is a risk of explosion if the battery
is not replaced correctly. Replace only with the
same or equivalent type. Never recharge non-
rechargeable batteries. Do not throw the batteries
into a fire. Do not expose batteries to excessive
heat. Do not short-circuit batteries. Doing so will
present a risk of explosion.
Used batteries should not be disposed of with
regular domestic waste! Instead, take them to
your local battery disposal point.
Replacing batteries
41