Replacing Batteries - HomeMatic IP HmIP-WRCC2 Montage- Und Bedienungsanleitung

Replacing batteries

mounting bracket (see figure 11). Make sure that
the openings of the battery compartment point
to the right and that the push-button properly
engages with the bracket.
6 Replacing batteries
If an empty battery is displayed via the app or the device
(see "7.4 Error codes and flashing sequences" on page
44), replace the used batteries by two new LR44
batteries. You must observe the correct battery polarity.
To replace the batteries of the wall-mount remote control,
please proceed as follows:
• Once mounted, the push-button can easily be
pulled out of the wall mounting bracket (E).
To remove the push-button (A) from the wall
mounting bracket, take hold of the sides of the
push-button and pull it out (see figure 12).
• Turn over the push-button.
• Use a non-metallic object (e.g. a pen) to push the
batteries out of the bracket (F) through the small
openings (see figure 13).
• Insert two new 1.5 V LR44 batteries into the
battery compartment, making sure that you insert
them the right way round (see figure 2).
Insert of the push-button (A) back into the wall
•
mounting bracket (see figure 11). Make sure that
40