Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Original instructions VARILEX
11. Switching on and off
Always guide the machine with both hands.
Switch on first, then guide the accessory towards
the workpiece.
Avoid inadvertent starts: always switch the tool off
when the plug is removed from the mains socket
or if there has been a power cut.
The machine must not be allowed to draw in
additional dust and shavings. When switching the
machine on and off, keep it away from dust deposits.
After switching off the machine, only place it down when
the motor has come to a standstill.
In continuous operation, the machine continues
running if it is forced out of your hands. Therefore,
always hold the machine with both hands using the
handles provided, stand securely and concentrate.
Mains powered machine VARILEX
Torque activation (with dead man's lever):
Switching on: See page 3, figure A10.
Slide the trigger switch (A2-3) forwards and then push
the trigger switch (A2-3) upwards.
Switching off: Release the trigger switch (A2-3).
Continuous operation:
Switching on: See page 3, figure A11.
Switch the machine on as described above. Now slide
the trigger switch (A2-3) forwards again and release
in the front position to lock the trigger switch (A2-3)
(continuous operation).
Switching off: Push the trigger switch (A2-3) upwards
and release.
Cordless machine VARILEX
Switching on: See page 5, figure B14.
Push the sliding switch (B2-5) forwards. For continuous
operation, now tilt it downwards until it engages.
Switching off: Press the rear end of the slide switch
(B2-5) and release it.
28
1802 HT / VARILEX
®
1802 HT:
®
AKKU HT:
®
AKKU PRO HT
®
12. Troubleshooting
12.1 Mains powered machines:
The electronic signal indicator (A2-1) lights up
and the load speed decreases. There is too
much load on the machine! Run the machine in
idling until the electronic signal indicator switches off.
The machine does not start. The electronic
signal indicator (A2-1) flashes. The restart
protection is active. If the mains plug is inserted
with the machine switched on or if the power supply is
restored following an interruption, the machine does not
start up. Switch the machine off and back on again.
12.2 Cordless machines:
• The electronic signal indicator (B1-2) lights up
and the load speed decreases. The temperature
is too high! Run the machine in idling until the
electronic signal indicator switches off.
• The electronic signal display (B1-2) flashes and
the machine does not start. The restart protection is
active. The machine will not start if the battery pack is
inserted while the machine is on. Switch the machine
off and back on again.
13. Maintenance
Disconnect the mains plug or remove the battery pack
from the machine before starting any maintenance work.
It is possible that particles deposit inside the power tool
during operation. This impairs the cooling of the power
tool. Conductive build-up can impair the protective
insulation of the power tool and cause electrical hazards.
The power tool should be cleaned regularly, often and
thoroughly through all front and rear air vents using a
vacuum cleaner or by blowing in dry air.
Prior to this operation, separate the power tool from the
power source and wear protective goggles and a dust
mask.
www.eisenblaetter.de
Werbung
Kapitel
Inhaltsverzeichnis
