Attaching The Tools, Working Notes; Placing The Grinding Disc In Position; Working Instructions - eisenblatter VARILEX 1802 HT Originalbetriebsanleitung

Note: 100% CAS compatible.
The supplied battery packs are compatible with
other Cordless Alliance System (CAS) tools. Find out
more on the website www.cordless-alliance-system.com.
Removing and inserting the battery pack:
To remove: See page 5, figure B7
Press the battery pack release button (B1-5) and pull the
battery pack (B1-4) downwards and out.
To insert: See page 5, figure B6
Slide the battery pack (B1-4) in until it engages.

10. Attaching the tools, working notes

Prior to any conversion work: Pull the mains plug
from the socket. The machine must be switched
off and the spindle at a standstill.
For reasons of safety, attach the cutting safety
cover before performing cutting-off operations
(see chapter 8. Accessories).
10.1 Locking the spindle:
• Press in the spindle locking button (A8-1/B12-1) and
turn the spindle by hand until the spindle locking
button engages.

10.2 Placing the grinding disc in position:

• Fit the support flange (A8-3/B12-3) on the spindle
(A8-2/ B12-2). The flange should not turn on the
spindle when properly attached. Screw support flange
with clamping wrench (A8-5/B12-5) so that the small
collar is facing upwards.
• Place the grinding disc on the support flange (A8-3/
B12-3). The grinding disc must lay flat on the
supporting flange.
A8-3 / B12-3
A8-3 / B12-3
A
A8-4 / B12-4
B A8-4 / B12-4
www.eisenblaetter.de
Original instructions VARILEX
10.3 Securing/releasing the clamping nut:
Securing the clamping nut:
The 2 sides of the clamping nut (A8-4/B12-4) are
different. Screw the clamping nut onto the spindle (A8-2/
B12-2) as follows:
1) For thin grinding discs:
The edge of the clamping nut (A8-4/B12-4) faces
A8-3 / B12-3
upwards so that the thin grinding wheel can be
attached securely.
2) For thick grinding discs:
The edge of the clamping nut (A8-4/B12-4) faces
A8-3 / B12-3
downwards so that the clamping nut can be attached
securely to the spindle (A8-2/B12-2).
Releasing the clamping nut:
Lock the spindle (see chapter 10.1). Turn the clamping
nut (A8-4/B12-4) anticlockwise using the clamping
wrench (A8-5/B12-5) to unscrew.

10.4 Working instructions:

Grinding and sanding operations:
Press down the machine evenly on the surface and move
back and forth so that the surface of the workpiece does
not become too hot.
Rough grinding:
Position the machine at an angle of 30° – 40° for the
best working results.
Cutting-off operations:
suitable for the material being processed. Do not tilt,
apply excessive force or sway from side to side.
Wire brushing:
Press down the machine evenly.
12
1802 HT / VARILEX AKKU PRO HT
® ®
A A8-4 / B12-4
B
A8-4 / B12-4
Always work against the run of the disc
(see illustration). Otherwise there is
the danger of the machine kicking
back from the cut out of control.
Guide the machine evenly at a speed
EN
12
27