Additional Safety Instructions - eisenblatter VARILEX 1802 HT Originalbetriebsanleitung

attempt to remove the cutting disc from the cut
while the disc is in motion otherwise kickback
may occur. Investigate and take corrective action to
eliminate the cause of wheel binding.
• Do not restart the cutting operation in the
workpiece. Let the disc reach full speed and
carefully reenter the cut. The disc may bind, walk
up or kickback if the power tool is restarted in the
workpiece.
• Support panels or any oversized workpiece to
minimize the risk of disc pinching and kickback.
Large workpieces tend to sag under their own weight.
Supports must be placed under the workpiece near
the line of cut and near the edge of the workpiece on
both sides of the disc.
• Use extra caution when making a "pocket cut" into
existing walls or other blind areas.
The protruding cutting disc may cut gas or water
pipes, electrical wiring or objects that can cause
kickback.
5.5 Safety warnings specific for sanding
operations:
• Do not use excessively oversized sanding disc
paper. Follow manufacturers recommendations
when selecting sanding paper. Larger sanding
paper extending beyond the sanding pad presents a
laceration hazard and may cause snagging, tearing of
the disc or kickback.
5.6 Safety warnings specific for wire brushing
operations:
• Be aware that wire bristles are thrown by the
brush even during ordinary operation. Do not
overstress the wires by applying excessive load to
the brush. The wire bristles can easily penetrate light
clothing and/or skin.
• If the use of a guard is recommended for wire
brushing, do not allow any interference of the
wire wheel or brush with the guard. Wire wheel or
brush may expand in diameter due to work load and
centrifugal forces.
5.7

Additional safety instructions:

WARNING – Always wear protective goggles.
• Use elastic cushioning layers if they have been
supplied with the grinding media and if required.
• Observe the specifications of the tool or accessory
manufacturer!
www.eisenblaetter.de
Original instructions VARILEX
• Accessories must be stored and handled with care in
accordance with the manufacturer's instructions.
• Ensure that accessories are installed in accordance
with the manufacturer's instructions.
• The tool continues running after the machine has
been switched off.
• The workpiece must lay flat and be secured against
slipping, e.g. using clamps. Large workpieces must be
sufficiently supported.
• If accessories with threaded inserts are used, the end
of the spindle may not touch the base of the hole
on the sanding tool. Make sure that the thread in the
accessory is long enough to accommodate the full
length of the spindle.
• The thread in the accessory must match the thread on
the spindle. See chapter 7. Technical specifications for
more information on the spindle length and thread.
• Damaged, eccentric or vibrating tools must not be
used.
• A damaged or cracked side handle must be replaced.
Never operate a machine with a defective side handle.
• Only use the machine if the protective cover is in
place.
• Always guide the machine with both hands on the
handles provided.
5.8 Special safety instructions for mains powered
machines:
• Pull the plug out of the socket before making
any adjustments, changing tools, carrying out
maintenance or cleaning.
• Before connecting the mains plug, make sure that the
machine is switched off.
• Use of a fixed extractor system is recommended.
• Always install an RCD with a maximum trip current of
30 mA upstream. If the power tool is shut down via the
RCD, it must be checked and cleaned. See chapter 13.
Maintenance.
5.9 Special safety instructions for cordless
machines:
• Remove the battery pack from the machine before
making any adjustments, changing tools, maintaining
or cleaning.
• Make sure that the tool is switched off before fitting
the battery pack.
1802 HT / VARILEX AKKU PRO HT
® ®
Protect battery packs from water and moisture!
EN
21