Accessories; Initial Operation - eisenblatter VARILEX 1802 HT Originalbetriebsanleitung

8. Accessories

Only use original Eisenblätter battery packs and
Eisenblätter accessories.
Use only accessories that fulfil the requirements and
specifications listed in these operating instructions.
Cutting disc cover clip / safety cover for cut-off
grinding:
Designed for work with cutting disc and diamond cutting
discs. Once the cutting disc cover clip is fitted, the safety
cover becomes a cutting safety cover.
8.1 Accessories power tools and cordless operated
power tools:
Art. no. Description
65041 3D ball handle
8.2 Accessories power tools:
Art. no. Description
65042 Safety cover Ø 125 mm
65043 Safety cover Ø 150 mm
65045 Cutting disc cover clip Ø 125 mm
65046 Cutting disc cover clip Ø 150 mm
65048 Protective suction cover Ø 125 mm
8.3 Accessories cordless operated power tools:
Art. no. Description
50463 CAS battery 5,5 Ah
50473 CAS battery 8,0 Ah
50474 High-speed charging device
Use abrasive tools made from Eisenblätter for best work
results, such as:
• Cutting discs and rough grinding discs
• Flap discs
• Fibre discs
• Cleaning discs
• Backing plates
• Quick-change systems for discs
Note: Accessories shown or described are not
part of the standard delivery scope of the product.
The complete program can be found on
www.eisenblaetter.de or in the catalog.
www.eisenblaetter.de
Original instructions VARILEX

9. Initial operation

9.1 Attaching the additional handle:
Always work with the additional handle (A1-4/
B1-3) attached! Attach the additional handle on
the left or right of the machine and secure.
9.2 Attach the safety cover:
For safety reasons, always use the safety cover
provided for the respective disc! See also chapter
8. Accessories.
Safety cover for grinding:
Designed for work with rough grinding discs, flap
sanding pads, diamond cutting discs.
See page 3, figures A6, A7 and A8 (power tools) or
page 5, figures B9, B10 and B11 (cordless operated
power tools).
• Push and hold the lever (A6-1/B9-1). Place the safety
cover (A7/B10) in the position indicated.
• Release the lever and turn the safety cover until the
lever engages.
• Push the lever and turn the safety cover until the
closed section is facing the operator (A8/B11).
• Make sure that the safety cover is placed securely:
The lever must engage and you should not be able to
turn the safety cover.
(Disassemble in reverse order.)
9.3 For mains powered machines only:
Before commissioning, check that the rated mains
voltage and mains frequency, as stated on the
type plate match your power supply.
Always install an RCD with a maximum trip current
of 30 mA upstream.
The red electronics signal indicator (A2-1) lights up
briefly when the mains plug is inserted in the socket,
indicating readiness for operation.
1802 HT / VARILEX AKKU PRO HT
® ®
Use only grinding tools that
are covered by at least 2 mm
by the safety guard.
EN
25