Attaching The Tools, Working Notes - eisenblatter VARILEX POLISHER HT Originalbetriebsanleitung

9.4 For cordless machines only:
Particulate matter protection cap:
Always attach the particulate matter protection
cap over the ventilation grille (B2-2) if the
surroundings are heavily polluted.
The machine heats up faster when the particulate
matter protection cap is fitted. It is protected by
the electronics system from overheating.
Attachment: See page 4, figure B3/B4.
Place the particulate matter protection cap over the
ventilation grille (B2-2) as shown.
To remove: See page 4, figure B5.
Hold the particulate matter protection cap by the upper
edges, raise it slightly and then pull it downwards and
remove.
Tip: Take a tool such as e.g. a screwdriver to help.
Rotating battery pack:
See page 5, figure B8.
The rear section of the machine can be rotated 270°
in 3 stages, thus allowing the machine's shape to be
adapted to the working conditions. Only operate the
machine when it is in an engaged position.
Battery pack:
Charge the battery pack (B1-4) before use.
Recharge the battery pack if performance diminishes.
The ideal storage temperature is between 10°C and
30°C.
"Li-Power, LiHD" lithium ion battery packs have a capacity
and signal indicator (B1-2):
- Press the button (B1-1), the LEDs indicate the charge
level.
- The battery pack is almost flat and must be recharged if
one LED is flashing.
Capacity and signal indicator:
The capacity and signal indicator (B1-2) displays the
charge status of the battery pack for approx. 2 seconds
when the button (B1-1) is pressed:
approx. 75 – 100%
approx. 50 – 75%
approx. 25 – 50%
approx. 15 – 25%
< approx. 15%
Recommendation: Charge the battery pack
before any further use.
www.eisenblaetter.de
Original instructions VARILEX
other Cordless Alliance System (CAS) tools. Find out
more on the website www.cordless-alliance-system.com.
Removing and inserting the battery pack:
To remove: See page 5, figure B7
Press the battery pack release button (B1-5) and pull the
battery pack (B1-4) downwards and out.
To insert: See page 5, figure B6
Slide the battery pack (B1-4) in until it engages.

10. Attaching the tools, working notes

off and the spindle at a standstill.
10.1 Placing the grinding disc in position:
• Fit the support flange (A6-2/B9-2) on the spindle
(A6-1/ B9-1). The flange should not turn on the spindle
when properly attached. Screw support flange with
clamping wrench (A6-4/B9-4) so that the small collar
is facing upwards.
• Place the grinding disc on the support flange (A6-2/
B9-2). The grinding disc must lay flat on the
supporting flange.
POLISHER HT / VARILEX
®
Note: 100% CAS compatible.
The supplied battery packs are compatible with
Prior to any conversion work: Pull the mains plug
from the socket. The machine must be switched
A6-2 / B9-2
A6-2 / B9-2
A
A6-3 / B9-3
B A6-3 / B9-3
EN
POLISHER AKKU
®
12
23