Accessories; Initial Operation - eisenblatter VARILEX POLISHER HT Originalbetriebsanleitung

EN
Original instructions VARILEX

8. Accessories

Only use original Eisenblätter battery packs and
Eisenblätter accessories.
Use only accessories that fulfil the requirements and
specifications listed in these operating instructions.
8.1 Accessories power tools and cordless operated
power tools:
Art. no. Description
65041 3D ball handle
8.2 Accessories cordless operated power tools:
Art. no. Description
50463 CAS battery 5,5 Ah
50473 CAS battery 8,0 Ah
50474 High-speed charging device
Use abrasive tools made from Eisenblätter for best work
results, such as:
• Flap discs
• Polishing discs
• Cleaning discs
• Backing plates
• Quick-change systems for discs
Note: Accessories shown or described are not
part of the standard delivery scope of the product.
The complete program can be found on
www.eisenblaetter.de or in the catalog.
22
POLISHER HT / VARILEX
® ®
9.1
type plate match your power supply.
The red electronics signal indicator (A2-1) lights up
briefly when the mains plug is inserted in the socket,
indicating readiness for operation.
Setting speed:
Set the recommended speed at the thumbwheel (A2-2).
(Small number= small speed; large number = high
speed)
The VTC electronics make material-compatible work
possible and an almost constant speed, even under load.
The best way to determine the ideal speed setting is by
performing a test.
surroundings are heavily polluted.
and metal particles. The particulate matter protection cap
(A5) is recommended for fine dust.
by the electronics system from overheating.
Dust Prevent System:
To remove: See page 2, figure A3.
To remove the Dust Prevent System (A1-2), first remove
the locking screw on the bottom with a torque screw-
driver. Then you can slide the Dust Prevent System over
the cable and remove it upwards.
Attachment: Pull the Dust Prevent System (A1-2) over
the cable to the ventilation slots of the machine. Then fix
it with the locking screw on the bottom.
Particulate matter protection cap
Attachment: See page 2, figure A4/A5.
Fit the particulate matter protection cap as shown.
POLISHER AKKU

9. Initial operation

Always work with the 3D ball handle (A1-3/B1-3)
attached!
For mains powered machines only:
Before commissioning, check that the rated mains
voltage and mains frequency, as stated on the
Always install an RCD with a maximum trip current
of 30 mA upstream.
1 820 min
-1
2 1,380 min
-1
3 1,760 min
-1
Always fit the Dust Prevent System (A1-2) or the
particulate matter protection cap (A5) if the
Recommendation: Use the Dust Prevent System
(A1-2) to protect your machine from coarse dust
The machine heats up faster when the particulate
matter protection cap (A5) is fitted. It is protected
4 2,260 min
-1
5 2,760 min
-1
6 3,000 min
-1
www.eisenblaetter.de