Wiring Connection - Kenwood KDC-X7100DAB Bedienungsanleitung

INSTALLATION/CONNECTION

Wiring connection

Rear/Front/Subwoofer output
For 3-way crossover: Tweeter/Mid Range/Woofer output
Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring harness as
illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
NOTE: Total output for Blue/White wire ( *
If your car does not have an ISO terminal:
We recommend installing the unit with a commercially available custom
wiring harness specific for your car and leave this job to professionals for
your safety. Consult your car audio dealer.
When connecting to an external amplifier, connect its ground wire to the
car's chassis to avoid damaging the unit.
Antenna terminal
DAB antenna jack ( 5)
Ignition wire (Red)
Unit
Battery wire (Yellow)
1 ) + ( * 2
) is 12 V 350 mA.
Microphone input jack ( 12)
Fuse (10 A)
Yellow (Battery wire)
Light blue/yellow
Red (Ignition wire)
(Steering remote
control wire)
Red (A7)
Blue/White *
(Power control wire/
Antenna control wire)
Yellow (A4)
Brown
(Mute control wire)
ISO connectors
(See Wiring for ISO
connectors, 30)
USB 1 cable (DC 5V
USB 2 cable (DC 5V
Auxiliary cable
If no connections are made, do not let the wire come out
from the tab.
STEERING WHEEL
REMOTE INPUT
To the steering wheel
REMOTE CONT
remote control adapter
To the power control terminal
2 ANT CONT
when using the optional power
P. CONT
amplifier or to the antenna control
terminal in the vehicle
To connect the Kenwood
navigation system, refer your
MUTE
navigation manual
1.5A)
1.5A)
31
ENGLISH