Special Functions; Direct Access - Fagor C60T379A2 Gebrauchsanweisung

C60T376A8.qxd 14/3/07 16:21 Página 11

SPECIAL FUNCTIONS

IMPORTANT
By using the "BOOSTER" function, if the other hob is switched on the same side of the
hobplate, the maximum power level which can be used is 6. This is due to the fact that in
this function the appliance takes power from the adjacent hob.
Downloaded from www.Manualslib.com

DIRECT ACCESS

Allows you to access a determined power level at any moment
Press the button
power level (The power level defined by the manufacturer is 8), but the
user can change the value of this power level by following these
steps.
Modification of the direct access power
(With the hob switched off)
1. Keep the button
2. The power level which has been defined will flash on the display.
3. Modify the power level with the "-" and "+" power buttons (B).
4. Press the button
TOTAL 5. Switch off the hob.
This allows you to always be able to trip the power for a certain time. This gives
the user total flexibility.
1. Start with the hob switched on and a determined power level.
2. Press the button
level and the time which it is going to be active.
The power level is adjusted with the "-" and "+" buttons in zone (B)
and the duration is adjusted using the "-" and "+" buttons in zone (E).
3.Then validate by pressing the button
4.The new power level is displayed with a dot.
5.Once the time has passed, return to the initial position and the dot will
disappear.
BOOSTER
The cooking areas are equipped with a "BOOSTER" function. This function
means that the maximum temperature can be obtained quickly.
1.Press the button
The hob power display will display (bo) and the hob will start to give
maximum power.
2.Once the hob has heated up, select the chosen power level by
pressing the "-" button in zone "B".
The "BOOSTER" function will be cancelled by pressing any other power
sensor associated with the hob, or with the on/off sensor.
manuals search engine
and the hob will heat up to a determined
pressed down until a beep sounds.
again to validate the operation.
and then you can enter the new power
11