Starting A Warm Engine; Stopping The Engine - Echo PB-265ESL Bedienungsanleitung

Engine warm-up

Starting a warm engine

1. Throttle position lever
1. Purge bulb
1. Recoil starter handle

Stopping the engine

1. Throttle position lever
Engine operation
1. Once the engine starts, allow it to warm up for 2 to 3 minutes
at idling (i.e. low speed).
2. Warming the engine helps to lubricate its internal workings
more smoothly. Allow the engine to warm up fully, especially
when it is cold.
3. Never run the engine without the blower pipes fitted.
The starting procedure is the same as Cold Start except DO
NOT close the choke.
1. Throttle Position Lever
Move throttle position lever to START/IDLE DETENT posi-
tion( ).
2. Purge Bulb
Pump purge bulb until fuel is visible and flows freely in the
clear fuel tank return line.
3. Recoil Starter
Pull recoil starter handle and engine should start.
NOTE
If engine does not start after 5 pulls, use cold start procedures.
1. Throttle Position Lever
Move throttle position lever to idle detent position(
allow engine to return to idle before shutting off engine.
2. Move throttle lever to "
If engine does not stop when throttle lever is moved to
STOP position, close choke -
Have your ECHO dealer repair stop switch before using
blower again.
17
" (Stop) position.
WARNING
position - to stall engine.
) and