MADRIX NEBULA Kurzanleitung & Technisches Handbuch Seite 8

1) Connecting Your LEDs
See chapter 'Connection Diagram Variations' on page 8 for all possible variations.
Step 1) Completely switch off your supply of power before connecting your
LEDs to the device!
Step 2) Connect your LEDs to the provided 4-pin screw terminals:
» The max. recommended wire length between NEBULA and LEDs or between
LEDs depends on the protocol, signal frequency, cables, and cable shielding.
» You may connect only to Port 1, only to Port 2, or to Port 1 and Port 2.
» Pay attention where to connect GROUND, DATA, CLOCK, and V+; as
indicated on the LEDs and the device as well as required by the diagram.
» You may connect 4-pin LEDs as well as 3-pin LEDs without CLOCK.
» Insert each individual wire consecutively and tighten the corresponding
screw with a suitable screw driver.
Step 3) Plug the 4-pin screw terminals into the device. The screws must face
upwards.
Step 4) Supply your LEDs with power (per port or jointly) as per their manual.
Step 5) Continue with the chapter '2) Connecting To Power And Data' below.
2) Connecting To Power And Data
See chapter 'Connection Diagram Variations' on page 8 for all possible variations.
Step 1) Be careful when handling the device and electrical power! Completely
switch off your supply of power before connecting to the device!
Step 2) Connect your power cables to the provided 2-pin screw terminal:
» Pay attention where to connect + and –; as indicated on the device.
» Insert each individual wire consecutively and tighten the corresponding
screw with a suitable screw driver.
Step 3) Plug the 2-pin screw terminal into the device. The screws must face
upwards.
Step 4) Connect to USB or to Ethernet network for data as required.
Step 5) Do not switch on your supply of power until all required power cables
and LEDs are connected to MADRIX
Step 6) Continue by selecting the required output protocol as described in
chapter '3) Device Configuration' on page 13.
7
EN
NEBULA.
®