How To Install On DIN-Rails
Unmounting (Pictured Right)
Step 1) Pull the unlocking clip.
Step 2) Lift the lower part of the device from the
rail in an angle.
Step 3) Lift the device from the rail.
Using The MADRIX
You can mainly use 3 operating modes together with the MADRIX
Output Via Art-Net
Output Via Streaming ACN
Output Via USB
First, make sure to activate the correct drivers in the MADRIX
– For USB, go to 'Preferences' > 'Options...' > 'Devices USB',
– For sACN, go to 'Preferences' > 'Options...' > 'Devices Network',
– For Art-Net, go to 'Preferences' > 'Device Manager...' > 'Art-Net'.
Second, configure and activate your devices in order to send data:
– Go to 'Preferences' > 'Device Manager...' > 'DMX Devices'.
For more information, please read the MADRIX
15
EN
Mounting (Pictured Left)
Step 1) Hook the device in an angle onto the upper
edge of the rail.
Step 2) Pull the unlocking clip.
Step 3) Press the lower part of the device against
the rail and let the clip snap into position.
5 Software
®
®
5 user manual.
®
5 Software:
®
5 Software: