Cleaning & Maintenance - Bosch TDI 902836A Gebrauchsanleitung

6. Shot of steam
shot

See the leaflet sides
This can be used to remove stubborn wrinkles
or to press in a sharp crease or pleat.
1. Set the temperature control (15) to "max".
2. Press the shot of steam button (7) on the
handle repeatedly at intervals of 5 seconds.
7. Vertical steam

See the leaflet sides
This can be used to remove creases from
hanging clothes, curtains etc.
1. Set the temperature control (15) to "max".
2. Hang article of clothing on a clothes hanger.
3. Operate the iron in a vertical position at a
distance of 10 cm / 4 in, and press the shot of
steam button (7) repeatedly with pauses of at
least 5 seconds.
8. Ironing without steam

See the leaflet sides
This enables the iron to be used for dry ironing.
1. Grip the handle (1) and set the steam control
to the setting.
2. While ironing, do not press the steam
activation button (2*).
9. Anti drip system
DripStop

See the leaflet sides
If the temperature control (15) is set too low
(below "••"), the steam is automatically switched
off to prevent water from dripping out of the
soleplate (13).
10. Spray

See the leaflet sides
This can be used to remove stubborn wrinkles.
When ironing, press the spray button (6) and
water will spray out of the spray nozzle (10) onto
the garment.
☞
Tips for ironing: Do not use the spray
function with silk as staining may occur.
18
B O SC H
11. After ironing

See the leaflet sides
1. Unplug the iron from the mains socket.
2. Open the water inlet lid (9).
3. Hold the iron with the front facing down and
shake it gently until the water tank (11) is
empty.
4. Close the water inlet lid.
5. Set the iron aside in a vertical position to cool
down.
6. Set the temperature control (15) to "•".
7. Coil the power cable (18) loosely around the
heel of the iron, before storing.
8. Store the iron in an upright position.
Tips to help you save energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
1. Regulate the steam according to the selected
ironing temperature, following the instructions
in this manual. Iron at "eco" steam setting (see
"setting the steam amount" section).
2. Try to iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the
iron. If you tumble dry your fabrics before
ironing them, set the tumble drier on the 'iron
dry' programme.
3. If the fabrics are damp enough, set the steam
to the position (see "ironing without steam"
section).
Cleaning & Maintenance

See the leaflet sides
E
Attention ! Risk of burns !
Always unplug the appliance from the
mains supply before carrying out any
cleaning or maintenance operation on it.
1. If the iron is only slightly soiled, pull out the
plug and allow the soleplate (13) to cool down.
Wipe the housing and the soleplate with a
damp cotton cloth only.
2. If the cloth is synthetic, it may melt due to the
high temperature on the soleplate, switch off
* Model dependent