Probuilder 32873 Handbuch Seite 26

The protective shield must be positioned to
protect the user if the grinding disc shatters
during use, causing parts to � y out.
Fitting a disc
Press and hold down the spindle lock (1) to
secure the spindle. Turn the spindle until it
locks. Remove the � anges using the spanner
provided.
Fit the inner � ange and the required disc on
the spindle and screw the outer � ange back
on the spindle.
26
Turn the � anges so that they match the
thickness of the washer. For thick washers,
the edges of the � anges should face in
towards one another. For thin washers, the
outer edge of the � ange should face away
from the inner � ange.
Release the spindle lock.
Switch the angle grinder on and let it run
for 30 seconds to check that it is working
correctly and that there are no abnormal
vibrations.
Stop the grinder immediately if heavy
vibration occurs, and investigate the cause.
Use
Connect the angle grinder to the power
mains. The indicator lamp (4) lights up when
power is fed to the angle grinder.
Take hold of the handle (3) and support grip
(6). Turn the angle grinder on with the on/off
switch.