MSI X38 Diamond Serie Bedienungsanleitung Seite 30

LED POST: POST
This LED tells the POST (Power on self test) process. The regular POST processes
are: CPU => DRAM => MCH => ICH => CLK => VGA => LOGO (or POST) => ATA =>
MSIJ . W hen the POST is complete, the necessary hardware of the system is de-
tected and found to function properly, the LED displays "MSIJ ". If the LED stops
showing the message in sequence, or does not show the "MSIJ" at last, that mean
there is something wrong with the system, In this case, the showing message tells
the hardware not being detected or is not functioning properly. Please refer to the
table below to get more information about the LED message.
Post
CPU
DRAM
MCH
ICH
CLK
VGA
LOGO
POST
ATA
MENU
CMOS
BIOS
MSIJ
En-22
Downloaded from www.Manualslib.com
M S-7353 M ainboard
Status
CPU is not detected or is not operating properly.
Memory is not detected or is not operating properly.
North bridge is not detected or is not operating properly.
South bridge is not detected or is not operating properly.
Clock generator is not detected or is not operating properly.
Graphics card is not detected or is not operating properly.
Logo is enabled and is showing on the screen.
Logo is disabled to be shown.
IDE or SATA device is not detected or is not operating properly.
F11 is pressed to select the boot device.
Checksum CMOS is failed.
checksum CMOS is failed, and F1 is pressed to enter the BIOS Setup.
Or the system is in the BIOS Setup.
The operating system is loaded properly.
manuals search engine