Installation; Installation Procedure For Windows 98 Se - Belkin F5U508 Benutzerhandbuch

P73954ec-A-F5U508-man.qxd 22-11-2002 15:41 Page 5
Please refer to the section that corresponds to your version
of the Windows operating system.

Installation Procedure for Windows 98 SE

This installation procedure will successfully install two USB 1.1
OHCI controllers, one USB 2.0 EHCI host controller, and one
IEEE 1394 host controller.
1. Insert the F5U508 installation CD into your CD-ROM drive.
2. Select "Install USB 2.0 Driver". After the driver is installed
3. Open the Start menu in the lower left hand corner of your
4. Once the computer has completely shut down, remove the
5. Remove the port cover that corresponds with the PCI slot
6. Insert the PCI Card into the slot. Apply pressure as needed
7. After installing the PCI Card, replace the outer cover and
Downloaded from www.Manualslib.com
After a few moments the main menu will auto-start and
display each of the available installation options.
select "No, I will restart my computer later". Select "Close".
Then select "Exit".
Windows display, then select "Shut Down" and click "OK".
computer's cover and locate an empty PCI slot.
you wish to use. (The cover is usually held in place with a
single screw).
until the card is fully seated. Secure the PCI card with the
screw removed in step #5, above.
turn on the computer.
manuals search engine

Installation

5
En