Belkin F5U508 Benutzerhandbuch Seite 13

P73954ec-A-F5U508-man.qxd 22-11-2002 15:41 Page 9
3. Open the Start menu in the lower left-hand corner of your
4. Once the computer has completely shut down, remove the
5. Remove the port cover that corresponds with the PCI slot
6. Insert the PCI Card into the slot. Apply pressure as needed
7. After installing the PCI Card, replace the outer cover and
8. When Windows restarts the PCI card will be detected and
Note: Depending on the speed of your computer, it may take
up to 30 seconds for the PCI card to be detected.
Verifying Proper Installation (Windows 2000)
After installation is complete, check the Windows Device
Manager to confirm that all components of the PCI Card have
been properly installed.
Downloaded from www.Manualslib.com
Installation (continued)
select "No, I will restart my computer later". Select "Close".
Then select "Exit".
Windows display, then select "Shut Down" and click "OK".
computer's cover and locate an empty PCI slot.
you wish to use. (The cover is usually held in place with a
single screw).
until the card is fully seated. Secure the PCI card with the
screw removed in step #5, above.
turn on the computer.
all required drivers will be automatically installed. After the
install is complete, you may be prompted to click finish and
to restart.
manuals search engine
9
En