Belkin F5U508 Benutzerhandbuch Seite 21

P73954ec-A-F5U508-man.qxd 22-11-2002 15:41 Page 17
8. The IEEE 1394 Network Device is now detected and
The Installation procedure is now complete.
Without Internet Connection
1. Insert the F5U508 installation CD into your CD-ROM drive.
2. Select "Install USB 2.0 Driver".
3. Windows will now display the following message: "The
4. Windows will now prompt you to restart your computer.
5. Open the Start menu in the lower left-hand corner of your
6. Once the computer is completely shut down, remove the
7. Remove the port cover that corresponds with the PCI slot
8. Insert the PCI Card into the slot. Apply pressure as needed
Downloaded from www.Manualslib.com
Installation (continued)
installed. Windows will present you with the option of
setting up a Network. If you do not want to set up an IEEE
1394 network, ignore this option. (Please check your
Windows XP help file for more information on setting up
and using an IEEE 1394 network).
After a few moments the main menu will auto-start and
display each of the available installation options.
software you are installing has not passed Windows
logo testing". Ignore this message and select
"Continue Anyway".
Select "No, I will restart my computer later". Click "Close".
Windows display, then select "Shut Down" and click "OK".
computer's cover and locate an empty PCI slot.
you wish to use. (The cover is usually held in place with a
single screw).
manuals search engine
17
En