Belkin F5U508 Benutzerhandbuch Seite 22

P73954ec-A-F5U508-man.qxd 22-11-2002 15:41 Page 18
9. After installing the PCI Card, replace the outer cover and
10. When Windows restarts, the PCI card will be detected and
Note: Depending on the speed of your computer, it may take
up to 30 seconds for the PCI card to be detected.
11. Windows will now search for drivers for the "Belkin USB 2.0
12. Drivers for the "Belkin USB 2.0 High Speed Host Controller"
13. Installation of the "Belkin USB 2.0 High Speed Host
14. Windows will now detect the "USB 2.0 Root Hub Device".
15. Drivers for the "USB 2.0 Root Hub Device" will now be
Downloaded from www.Manualslib.com
Installation (continued)
until the card is fully seated. Secure the PCI card with the
screw removed in step #7, above.
turn on the computer.
drivers for both the IEEE 1394 host controller and the two
USB OHCI host controllers will be automatically installed.
High Speed Host Controller" and the "New Hardware
Wizard" will start. Select "Install the software automatically
(Recommended)". Click "Next".
will now be located. Windows will display the following
message: "The software you are installing has not passed
Windows logo testing". Ignore this message and select
"Continue Anyway".
Controller" will now be completed. Click "Finish".
Click "Next".
located. Windows will display the following message.
"The software you are installing has not passed
Windows logo testing". Ignore this message and
select "Continue Anyway".
manuals search engine
18