Change the Autoloader Display Name
Use Gemini Utilities to enter the name displayed on the operator panel.
1.
2.
3.
4.
Enable the Beeper
You can change the number of beeps that occur when the unit is out of media or
there is an error.
1.
2.
2000447_C
Downloaded from
www.Manualslib.com
Select the Override Name checkbox.
Clear the Use Computer Name checkbox.
In the Display Name field, enter the new name.
Select Set DiscLab Params to set the name.
In the # of Beeps on Fault field, select the number of beeps you wish to
hear when there is an error.
Tip: To disable the beeper, set the number to zero.
Select Set DiscLab Params to set the number of beeps.
manuals search engine
Operate Gemini Utilities
27