Check The Disc Alignment - Rimage Professional 5000N serie Benutzerhandbuch

Check the Disc Alignment

1.
2.
24
Downloaded from www.Manualslib.com
Rimage Professional 5100N and 5300N User Guide
Observe the gap between the edge
of the disc and the raised edges
of the printer tray as shown by the
arrows. The disc should be centered
on the printer tray.
•
If the disc requires side to side
alignment, continue to step 2.
•
If the disc requires front to
back alignment, continue to
step 3.
If necessary, perform a side to side alignment.
a. Loosen the two side to side
alignment screws.
b. Slide the printer until the
side gaps are equal.

Important! Slide the
entire printer, not the
printer tray.
c. Tighten the two side to side
alignment screws.
manuals search engine
Printer Tray
Side to Side Alignment
Screws
2000447_C