Mettler Toledo M100/2H DR Leitfaden Für Die Einrichtung Seite 40

9. Calibrate sensor. Menu path: Device Setup > Sensor Calibration
10. Perform further settings. See Operating Instructions of the M100 transmitter.
Change Sensor Type
Prerequisite: The M100 transmitter and another sensor type are mounted and electrically
connected.
If you change the sensor type e.g. a Conductivity sensor with a pH sensor, perform the
following procedure:
1. Built up connection.
2. Select Sensor Setup.
Menu path: Detailed Setup > Measurements > Channel Setup > Sensor Setup.
3. Start "Sensor Setup".
4. Select the new sensor type for the Sensor Type parameter.
5. Load configuration from device.
6. The configuration in the configuration tool or in the HART handheld is updated. If you
have selected the correct sensor type, the "Verify" menu will be shown.
en
40