Troubleshooting; Electrical Circuit; Wiring Diagrams - Swim & Fun Heat Splasher 1295 Bedienungsanleitung

6.

Troubleshooting

Fault condition
Low air temperature protection
Water temperature sensor
error
Air temperature sensor error
Low pressure switch alarm

6.1 Electrical circuit

Wiring diagrams

Heat Splasher 1295
NOTE
The electrical wiring diagram above is for your reference only.
The heat pump must be earthed, even though the heat exchanger is electrically
isolated from the rest of the unit. Around the unit, it is still necessary to protect you
against short circuits inside the unit. Fixed installation is also required.
MV-1295-1296-1297-06-2019 . swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS
Code Reason
P0
Air temperature is too
low
P1
Water temperature
sensor open circuit or
short circuit.
P2
Air temperature sensor
open circuit or short
circuit.
EL
Low pressure switch
disconnected
Heat Splasher 1296 / 1297
Solution
Can only be used when the air
temperature rises above 12 °C
Water temperature sensor needs
to be replaced. Contact dealer
Air temperature sensor needs to
be replaced. Contact dealer.
Contact dealer
UK
51