Philips Sunmobile HB952 Bedienungsanleitung Seite 8

ENGLISH
8
Using the appliance
1 Fully unwind the mains cord.
2 Put the plug in the wall socket.
The remote control will show all the functions that need to be adjusted by the user.The
tanning or relax time is shown as 00 (fig. 15).
Only types HB951 and HB952 show the symbol ª: the symbol to tan your face.
Only types HB952 and HB955 show the symbol º: the symbol to tan a part of the body .
Only type HB955 shows the symbol – (relax).
Adjusting functions
1 Use the ¡ ™ buttons to switch from function to function (fig. 16).
The underlined symbol shows the function you are programming.
2 Selecting tanning, facial tanning, tanning a part of the body or relaxing.
Choose symbol • if you want to tan your whole body.
Choose symbol • and ª if you want to tan your whole body and give your face an extra tan (types
HB951 and HB952).
Choose º if you want to tan just a part of the body (types HB952 and HB955 only).
Choose symbols ª and º if you want to tan just a part of the body, including an extra facial tanning
(type HB952 only).
Choose symbol – if you prefer a relax session (warmth) for the whole body (type HB955 only).
Note: In these directions for use, functions ; ª are used as examples of what may be shown on the
display.
Setting the time for a tanning or relax session.
1 Set the time of the tanning or relax session by pushing the + button to put the time forward
or by pushing the - button to put the time backward (fig. 17).
Keep the button pressed in to adjust the time more quickly.
2 Lie down directly under the lamp units of the appliance to ensure that the sides of your body
are also tanned properly.
3 Put on the protective goggles provided.
Switch on the tanning lamps or the infrared lamps by pressing the start button ∞ (fig. 18).
4
Note: During start-up the tanning lamps may produce a humming sound.This sound will stop as
B
soon as the lamps are burning properly.
Note:The tanning lamps will start to emit a visibly stronger light after about 60 seconds, which
B
means they are now burning at full power. From this moment onwards you can switch the facial
tanner on or off.
Note: If the lamps fail to go on after about 20 seconds, switch the appliance off (∞), let the
B
lamps cool down for 3 minutes, set the tanning time and switch the appliance back on again
(∞).
A blinking signal will appear; the set time is shown on the display (25 minutes in this case)
(fig. 19).
The countdown of the set tanning or relax time will now start.
You can switch the facial tanner (• , ª) on or off during the session without having to switch
off the whole appliance (fig. 20).
(This also holds for the extra face tan in combination with º).
B
The chosen symbols stay visible in the display, but the other symbols do not.
During the last minute of the session you will hear an intermittent beeping sound (fig. 21).
Downloaded from www.Manualslib.com manuals search engine