Philips Sunmobile HB952 Bedienungsanleitung Seite 10

ENGLISH
10
This is convenient, because it enables you to use the tanning lamps again only 3 minutes after
switching them off.
The infrared lamps do not require a cooling down period before they can be switched on again.
B
If you have switched the tanning appliance off by removing the plug from the wall socket, the
B
fans won't provide cooling for three more minutes, of course.
If you have switched the tanning appliance off by removing the plug from the wall socket and
B
another person wishes to use the appliance for a tanning session right away, the newly set time
won'tblink on the display.This means that the next person will have to keep track of the three-minute
cooling-down period himself.
HB955 only: if you want to use the appliance for a tanning session immediately after having
B
used it for a relax session (–), you should also let the appliance cool down for three minutes. As
a result of the relax session, the tanning lamps will have become hot and will need to cool down
before they can be switched on.
Cleaning
1 Always unplug the appliance and let it cool down before you start cleaning it.
2 Clean the outside of the appliance with a damp cloth.
Do not let any water run into the appliance.
3 Do not use scouring pads.
Never use abrasive liquids like scouring agents, petrol or acetone to clean the appliance.
You can clean the outside of the UV filters with a soft cloth sprinkled with some methylated
spirits.
Storage
1 Let the appliance cool down for 15 minutes before you put it in transport position and store
it.
In the meantime, you can wind up the cords and put them in the base of the appliance.
2 Make sure the cords and remote control unit are stored properly, as they might otherwise
get stuck between parts of the appliance when you put the appliance in transport position
(fig. 26).
3 Firmly hold the upper part of the stand with one hand and loosen the height adjustment
knob (A) by turning it anti-clockwise (fig. 27).
4 Slide in the stand fully (fig. 28).
5 Firmly fasten the height adjustment knob (A) by turning it clockwise (fig. 29).
6 Turn the two lamp units towards each other (fig. 30).
7 Grab the handle with both hands, put one foot against the appliance to prevent it from sliding
away and tilt the upper part with the stand backward (fig. 31).
The automatic unlocking system will only work if you tilt the upper part with the stand
backward far enough. However, you should be careful not to tilt it backward too far because you
might lose your balance if you do.
8 Push the upper part down (fig. 32).
9 Lower it slowly onto the base (fig. 33).
10 Fasten the lamp units to the base by pushing both catches in the direction of the arrow
(fig. 34).
Downloaded from www.Manualslib.com manuals search engine