Topcom Twintalker 1300 Bedienungsanleitung Seite 7

12.2 ADJUSTING SPEAKER VOLUME
SC
TX RX
SC
TX RX
12.4 TRANSMITTING A SIGNAL
SC
TX RX
12.5 CHANGING CHANNELS
The PMR has 8 available channels.
To change channels:
SC
TX RX
12.6 MONITOR
You can use the MONITOR feature to check for weaker signals in the current channel.
• Press
• Press and hold
until you press
12.7 CHANNEL SCAN
CHANNEL SCAN performs searches for active signals in an endless loop from channel 1 to 8.
SC
TX RX
TOPCOM TWINTALKER 1300
Downloaded from www.Manualslib.com
The Speaker Volume can be adjusted using
12.3 RECEIVING A SIGNAL
The unit is continuously in the RECEIVE mode when the unit is ON and not transmitting. When you
receive a signal on the current channel, the RX icon is displayed.
In order for other people to receive your transmission, they must be set
on the same channel.
• Press and hold to TRANSMIT.
PTT
• Hold the unit in a vertical position with the MICROPHONE 10 cm from the mouth and speak into the
microphone.
• Release when you have finished transmitting.
PTT
• Press once, the current channel number flashes on the LCD Screen.
• Press or to change the channel.
• Press to confirm the channel selection and return to NORMAL mode.
PTT
NOTE: Any PMR set on the same channel can receive and listen to the conversation.
button for normal monitoring .
. After 5 seconds you can release the button. You are now continuous monitoring the channel
again.
• Press and hold and
• Release the buttons.The channel on the display changes as it scans through the channels.
• When an active signal (one of 8 channels) is detected, CHANNEL SCAN pauses and you will hear the
active signal.
• When an active signal (one of 8 channels) is detected, press
and continue to search for another active channel
• Press to communicate through the active signal channel or press
PTT
scan.
manuals search engine
/ . The Speaker Volume level is displayed on the LCD.
for 2 seconds.
TOPCOM TWINTALKER 1300
or to bypass the current channel
to deactivate channel
7