Switching On And Off In Sustained Operating Mode; Care And Maintenance - Hilti TE 500 Original Bedienungsanleitung

5.7.1 Chisel positioning
The chisel can be adjusted to 24 different positions (in 15° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
1. Push the accessory-tool release forward and hold it in this position.
2. Turn the accessory-tool release with the chisel to the desired position.
3. Let go of the accessory-tool release to lock the chisel in this position.
5.7.2 Chiseling
1. Slowly press the control switch.
Running speed can be controlled smoothly up to maximum by varying how far the control switch
is pressed.
2. To switch the power tool off, release the control switch.
5.7.3

Switching on and off in sustained operating mode

When chiseling, the control switch can be locked in the "on" position.
1. Press control switch 1 and then press control switch lock 2.
2. Release control switch 1 and then release control switch lock 2.
▶ The power tool then runs in sustained operating mode.
3. To switch off continuous operation, press control switch 1 and then release it.
▶ The power tool switches off.
6

Care and maintenance

WARNING
Electric shock hazard! Attempting care and maintenance with the supply cord connected to a power outlet
can lead to severe injury and burns.
▶ Always unplug the supply cord before carrying out care and maintenance tasks.
Care
• Carefully remove any dirt that may be adhering to parts.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
16 English
5
2227844
*2227844*