Technical Data - Hilti TE 500 Original Bedienungsanleitung

3.3 Items supplied
Breaker, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

4.1 Breaker
For rated voltage, rated current, frequency and/or input power, refer to the country-specific type
identification plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the device. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the device.
This device complies with the applicable standard provided that the maximum permissible supply impedance
(Zmax) at the point where the user's installation is connected to the public supply network is less than or
equal to 0,401 Ω. It is the responsibility of the installer or user of the device to ensure, if necessary by
consultation with the supply network operator, that the device is connected only at a point where supply
impedance is less than or equal to Zmax.
Weight in accordance with EPTA procedure 01
Protection class in accordance with EN 60745
4.2 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise information
Sound power level (L
WA
Uncertainty for the sound power level (K
Sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration information
Chiseling (a )
h,Cheq
Uncertainty (K)
5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
14 English
)
)
WA
)
pA
)
pA
TE 500
4.9 kg
II
TE 500
95 dB(A)
3 dB(A)
84 dB
3 dB(A)
TE 500
13.4 m/s²
1.5 m/s²
2227844
*2227844*