Installation/ Connection - Victron energy Peak Power Pack Anleitung

4. If the output of the PPP is connected in
parallel to another power supply (e.g.
12V power supply unit of a caravan), is
the PPP protected against charging
from the caravan power supply unit
(e.g. by means of a diode)?
5. Is it correct to assume that the built-in
transformer brings the resistance loss
between the car battery and the PPP
to right charging voltage?
1. Does the PPP switch from the D-plus
of the car or through the normal plus?
2. What happens in case of a stop if the
PPP is connected to the normal plus?
3. Do I still need the main switch for my
Mover?
4. How can the PPP be installed?
5. Is the length of the cables between the
PPP and the Mover electronics
important?
6. I have had a mover with PPP installed.
14
V. INSTALLATION/ CONNECTION
case of misuse. See also "Interesting
facts".
Yes, if the PPP is charged with more
than 5A through the output, after 30
seconds an error message will
appear (and the output will be
disconnected). If lower current is
used for charging, after 15 minutes
the device is disconnected
automatically.
If within those 15 minutes one or
more cells are charged with too high
a voltage, an error message will
appear (and the output is
disconnected).
(Any other protections, such as
temperature monitoring, are also
always active.
That is correct. In the case of a low
12V input voltage (due to cable loss)
the PPP itself ensures the voltage is
transformed into a higher charging
voltage.
From the D-plus. It should therefore
be connected for the connection with
the caravan!
In that case, the car battery is
discharged if the engine is not
running.
No. The device switches on and off
through electronic switches. You can
turn the PPP on and off by means of
the switch on the device or by means
of a "remotely installed" push switch.
The PPP can be installed both
horizontally and vertically. However,
the connections for the switch, 12V
charging and the included adapter
are to be placed at the bottom side
for reasons of dust, humidity, etc.
Yes. They need to be as short as
possible (max. 1m); diameter
between 10 and 16 mm2. NO main
switch is required any more. You can
turn the PPP on/off by means of the
on/off button on the PPP or by means
of the included push button.
The mains adapter for the PPP can