Bec System / Connections To Receiver; Equipment For Combustion Engine - Carson REFLEX WHEEL II 2.4GHz Betriebsanleitung

BEC-System / Connections to receiver
GB
BEC RECEIVER : Battery eliminator is installed in the receiver circuitry. The receiver gets supplied with
current through the drive battery that runs the engine. Ni-MH battery from 6.0V to 8.4V can be used for
the receiver. Batteries of higher voltage may damage the receiver and servos.
Use only a speed controller which has the exclusive connector for the BEC system.
CARSON 7.2V
Racing-Pack
(not included)
Receiver
Do not connect a
separate power
supply to the
receiver!

Equipment for combustion engine

Receiver Batteries are not included in the kit.
Receiver
Make sure to
connect in
correct direction.
6 REFLEX WHEEL 2.4GHz CARSON Radio Control System 50 050 5004
Steering servo
Channel 1
Steering servo
Channel 1
One Servo included in the kit.
TAMIYA 7,2V TYPE
Connector
Always disconnect
if not in use!
Receiver switch
ATTENTION
Make sure that male and female
connectors have the correct polarity
Receiver switch
Throttle servo
Channel 2
Not included.
Available separately.
ATTENTION
When connecting servo leads to the receiver
always ensure that the yellow lead/wire is
facing inwards (towards the crystal).
Motor
Motor
connector
Electronic speed
controller
(not included)
Channel 2
Receiver battery case
NiMH-batteries item No.
609000 are recommended