External View Of Transmitter; Installing The Receiver And Antenna - Carson REFLEX WHEEL II 2.4GHz Betriebsanleitung

EXTERNAL VIEW OF TRANSMITTER

External view of transmitter
GB
Third Channel Switch
For additional ON/OFF function
Steering Rate Adjuster
Charging Jack
Battery
Compartement
Installing the receiver and receiver antenna
The receiver should be installed as far as possible
from the drive engine, the drive controller and the
cables that carry strong current. Vibration-
dampening mounting with thick, double-sided
foam adhesive pads has proven reliable here. In
addition, dirt protection (a cover or shell) is
recommended.
8 REFLEX WHEEL 2.4GHz CARSON Radio Control System 50 050 5004
ST.TRIM
Steering Trim
Throttle Trim
Swivel Antenna
Steering Wheel
Binding
( Setup) Button
The receiver's antenna should be directed out of
the body by the shortest vertical route through a
(plastic) antenna tube. Under no circumstances
should it come into contact with metal or carbon
parts, from which it should be at least 30 mm
away.
Power LED
Blinking LED indicates that
the batteries are getting weak.
When the LEDs go out, the
batteries must be charged or
replaced.
Power Switch
Throttle Trigger
Throttel
Servo Reverse
Channel 2
TH ST
Steering
Servo Reverse
Channel 1
Battery Cover