Klarstein Phantasma Cottage Pillar Handbuch Seite 29

IMPORTANT NOTES ON INSTALLATION
• Free-standing fireplaces and table-top appliances must be installed in a safe,
level, stable and non-combustible place.
• Wall fireplaces must be mounted on a flat, solid and stable wall with non-
combustible wall cladding in accordance with the instructions.
• Built-in fireplaces must be installed in a non-combustible cavity.
(1) This fireplace is operated with alcohol which has a low flash point and is volatile.
Have an expert installer check the environment before installing the unit.
(2) Installation is carried out on the basis of this manual.
(3) The environment within 50-60 cm of the chimney should be lined with heat resistant
materials.
(4) Make sure that the table fireplace/freestanding fireplace is on a flat table/floor
where it will not be touched when walking around. Keep children away from the
fireplace.
(5) Ensure that the burner is not exposed to strong wind.
OPERATION
Notes on the Fuel
• The alcohol used in the fireplace should be stored in a shady and safe place.
• Use 95% bio-ethanol refined from plants.
Note: Use only bio-ethanol as fuel.
Ignite Fire
(1) Slowly pour the fuel into a clean, cool burner or burner pot. Use the funnel for
filling. Fill the burner to a maximum of 2/3. Do not fill too much fuel and do not
allow the fuel to come into contact with objects other than the inside of the burner.
Replace the bottle cap and place the bottle far away before lighting. Store the fuel
bottle in a dry, cool room. Do not store it in places where it may be exposed to
direct sunlight and warm up.
Note: Spilled alcohol may stain floors or furniture.
EN
29