Technical Data And Further Information; Mounting; Electrical Connection - Mettler Toledo M200 Schnellstartleitfaden

2

Technical Data and Further Information

The most important technical data such as supply voltage are given on the name plate either
outside or inside the transmitter housing. For further technical data such as accuracy refer to
the Operation Manual. This document, the Operation Manual and software are on the supplied
CD-ROM. You can also download the documentation via Internet "www.mt.com/M200".
3

Mounting

The M200 transmitter is available as ½ DIN and ¼ DIN version.
For installation drawings refer to the Operation Manual.
1. ½ DIN only: Mount the supplied cable glands at the housing.
2. Mount the transmitter. You have the following possibilities:
• Panel mounting: ½ DIN and ¼ DIN version
• Wall mounting: ½ DIN
• Pipe mounting: ½ DIN
4

Electrical Connection

a
DANGER! Mortal danger by electric shock: Power off instrument during electrical connection.
h
Note: This is a 4-wire-product with an active 4–20 mA analog output. Do not supply power to
terminal no. 1 to 6 of terminal block TB2.
1. Switch off supply voltage.
2. Connect mains supply as follows:
• 20 to 30 V DC: –N for Neutral and +L for Line
• 100 to 240 V AC –N for Neutral and +L for Line
3. Connect relay output signals, analog output signals and digital input signals according
to the Operation Manual.
4. Connect sensor signal to terminal block TB3 and TB4 (only 2-channel version) accord-
ing to the Operation Manual.
en
32