Hot Air + Microwave In Combined Operation; Error Messages; Cooking In Several Steps; Special Functions - Clatronic MWG 757 H Bedienungsanleitung

Hot Air + Microwave in Combined Operation

Please proceed as follows for hot air combined operation:
1. Press the STOP/RESET button.
2. Press the MICRO.+CONVECTION button.
3. Press the MICRO.+CONVECTION button repeatedly to
select a temperature between 110°C, 140°C, 170°C and
200°C.
4. Set the desired cooking time between 10 seconds and
95 minutes using the rotating TIME/MENU button.
5. To start cooking press the START/QUICK START button.

Cooking in Several Steps

The programmes can be set in such a way that it is possible for
you to select three different functions.
Let us assume you select the following programmes for cooking:
Heating up Food in the Microwave
Cooking with Hot Air
1. Press the STOP/RESET button.
2. Press the MICRO. button.
3. Select the desired microwave power level by pressing the
MICRO. button once or several times.
4. Set the desired cooking time between 10 seconds and
95 minutes using the rotating TIME/MENU button.
5. Press the CONVECTION button.
6. Press the CONVECTION button repeatedly to select a tem-
perature between 110°C, 120°C, 130°C, 140°C, 150°C,
160°C, 170°C, 180°C, 190°C and 200°C.
7. Set the desired cooking time between 10 seconds and
95 minutes using the rotating TIME/MENU button.
8. To start cooking press the START/QUICK START button.
After the time has elapsed the oven switches off and the word
„END" appears in the display. Then you can remove the food.

Special Functions

Automatic Reminder
After cooking has fi nished you are reminded every 2 minutes by
a beep to remove the food.
This reminder is switched off by opening the door or pressing
the STOP/RESET button.
Disabling
Press the STOP/RESET button for more than 3 seconds to
disable the machine. The fact that the machine is disabled is
then shown in the display. The function of the operating controls
is now blocked. Press the STOP/RESET button again for more
than 3 seconds to reactivate the machine.
62
05-MWG 757 H 62

Error Messages

The symbols „E-1", „E-2", „E-3" or „E-4" may appear in the
display during operation. In this case there is a problem with the
electronic control system.
• Press the STOP/RESET button and repeat the procedure.
• If the fault occurs again, press the STOP/RESET button and
remove the mains plug from the socket.
Cleaning
Turn the microwave off and remove the mains plug.
Interior
• Keep the interior of the oven clean. Splashes and overfl o-
wing liquids on the walls of the oven can be removed with
a damp cloth. If the oven is very dirty a mild detergent can
also be used. Please do not use any abrasive detergents.
• Wipe off the viewing window on the inside and outside
with a damp cloth and remove splashes and stains from
overfl owing liquids regularly.
External Walls
• The external walls of the microwave should only be cleaned
with a damp cloth. Please ensure that no water enters the
openings in the housing and therefore inside the device.
• The switches should also only be cleaned with a damp
cloth. In order to clean the function switch, fi rst open the
microwave door to avoid switching on the device so acciden-
tally.
Accessories
• The glass plate should occasionally be cleaned with was-
hing-up liquid or in the dishwasher.
• The rotating ring and the inside fl oor of the oven should be
cleaned regularly. The rotating ring can be removed and
cleaned by hand. You may use a mild detergent or window
cleaner for this. Please dry thoroughly afterwards. Ensure
that the ring is put back in the correct position afterwards.
Odours
• In order to remove any unpleasant odours that may emanate
from the microwave, place a dish fi lled with water and lemon
juice that is suitable for microwave use in the oven and heat
it for approximately 5 minutes. Then wipe out the oven with
a soft cloth.
Oven light
• If you need to replace the lighting in the oven, please
contact a specialist workshop near you.
18.05.2006, 10:59:26 Uhr