Troubleshooting - JUFLO LED TABLE EVENT TABLE Bedienungsanleitung

4. TROUBLESHOOTING

In the following we list a few common
problems that may occur during opera-
tion. We give you some suggestions for
easy troubleshooting:
Symptom
The device can not be
controlled with the remote
control.
The light does not turn on.
The light flickers.
The flashes flashes.
Remedy
Light and remote control are not paired. Pair the
device with the remote control.
The light is in the wrong group. Select the correct
group.
The light is not connected to the power supply. Con-
nect the light to the USB power supply or to a power
bank.
Battery of the power bank is empty. Charge the power
bank.
Blackout is activated. Press [BLACKOUT] again or
The light is in sound-controlled mode. Press
the sound control.
Too many lights are connected to one USB mains
adapter. Only connect a maximum of 2 lights per USB
output to the power supply. CAUTION: If more than
2 lights are connected to one USB output, the USB
power supply will get damaged.
Hold down [SLOW] to pause the flash effect.
ENGLISH
.
, to end
37