Construction / Dismantling - JUFLO LED TABLE EVENT TABLE Bedienungsanleitung

LED TABLE
2. CONSTRUCTION /
DISMANTLING
Lay the table top with the top on
1
the floor. Ensure a clean surface to
protect the table top from sharp ob-
jects, such as stones or chips, from
scratches.
2 Take the table leg by the hand and
put them in the respective opening.
Pull the metal slide out until it stops,
insert the table base into the hole
and release the metal slide. To
strengthen the clamping effect,
you can turn the table leg clockwise
while pressing the metal slider. The
more you wiggle, the more jammed
the leg!
3 Make sure that each table leg is
inserted into the hole provided as far
as possible. Check this over the gap
between the tabletop and the metal
base.
To release the leg from the metal
4
base pull out the metal slider and
turn the leg counterclockwise at the
same time.
26
1
2
Caution
During the initial installation, it may
happen that the leg can be mounted
or dismantled with difficulty. But that
changes after the first applications and
the assembly becomes easy! (In the
production of the metal base, a paint
is applied which at the holes but after
repeated assembly or disassembly
removed.) Intentionally, we have at LED
Table, the construction at the point not
changed, otherwise in long-term opera-
tion no solidity could be guaranteed.